Enabling Feedback; Using Fullscreen Mode In Local Configurations - PRG MBOX DIRECTOR User Manual

Enabling Feedback

In order to view real-time feedback of Mbox Director scene content, either Mbox must be running in Fullscreen mode
(typical operation) or, if running in Window mode, the Mbox tab must be selected in the Mbox server window as
shown below.
If running in Window mode and the Mbox tab is not selected, dynamic movie content will not run on the Mbox
server or in the Mbox Director layer preview area!
Preview Area
Training Video: CITP – Streaming Feedback & Thumbnails:
http://www.youtube.com/watch?v=ZQMg9VmJYNM

Using Fullscreen Mode in Local Configurations

If Mbox Director and Mbox are running on the same computer, and you intend to use Mbox in Fullscreen mode, the
Fullscreen mode secondary display should be set to Output 2. This assumes that the Mbox is being used in Single
Output mode (not in one of the dual modes).
The Single Output Setup is configured at the Mbox Setup tab as shown below:
®
34 MBOX DIRECTOR USER MANUAL
Mbox Window
Mbox Tab
Mbox Director Window
Media Clip Preview Layer Content