18
•
OVERSCAN
Press to select overscan mode.
FREEZE
•
Freezes the projected image.
•
LAMP MODE
Press to display OSD menu to select desired light mode.
3D MODE
•
Press to display 3D setup menu.
•
INFO.
Press to display INFORMATION menu.
LIGHT
•
Press to open backlight of remote controller.
•
CLEAR
Clear remote ID SET assigned to all projectors.
Press CLEAR and ID SET for five seconds. The LED
blinks three times then the ID setting is cleared.
SHUTTER
•
The function is not available on this projector.
•
ID SET
•
Remote control ID SET (set the particular remote
code)
Press to set remote ID.
Press ID SET for three seconds. The POWER
indicator on the remote control blinks, then press
01~99 to designate an ID.
Note:
The remote control number (Remote control ID) must match the
Projector ID Setting number for accurate control.
•
Clear Remote ID SET (set remote code to all)
Press CLEAR and ID SET for five seconds. The
POWER indicator on the remote control blinks a
single instance to reset remote code to all, can control
projector no matter projector id setting.
Numeric buttons
•
Enters numbers in network settings.
Numeric buttons 1, 2, 3, 4 cannot be pressed when asked
to enter password.
•
WIRE REMOTE jack
Connect to projector for wire remote control.