Table of Contents
Advertisement
NL Basic settings
Basic settings
You can set up your device according to your needs.
Overview of the basic settings
The basic settings depend on the equipment of your appliance.
Basic setting
Water hardness
rinse aid
lilac
Sensor setting
Extra Dry
hot water
Factory setting (may differ depending on the device type)
1
40
Display text
Choise
H:04
H:00 - H:07
1
r:05
r:00 - r:06
1
SE:00
SE:00 - SE:02
1
d:00
d:00 - d:01
1
A:00
A:00 - A:01
1
Description
Set the water softener to the water
hardness.
→
"Setting water softening",
Page 29
At position H:00 the water
softening is switched off.
Set the amount of rinse aid.
→ "Amount of rinse aid
set", page 31
Switch off the rinse aid
with position r:00.
Set the water sensor for the dirt
detection.
→
"Sensors", Page 14
During the final rinse, the temperature
is increased, which results in better
drying results. As a result, the run time
may increase slightly.
Note Not suitable for
delicate items of crockery.
Switch on extra dry "d:01" or
switch off "d:00".
Set cold water connection or hot
water connection. Only set the
device to Hot water if the hot water
is prepared in an energetically
favorable way and a suitable
installation is available, eg a solar
boiler with circulation pipe. The
water temperature must be a
minimum of 40 °C and a maximum
of 60 °C. Switch on hot water
"A:01" or switch off "A:00".
Advertisement
Table of Contents
