Setting Water Softening; Softening Salt - Bosch SMV6ZCX42N Instructions Manual

Note Set the device to the
determined water hardness.
→ "Setting water softening",
Page 29
With a water hardness of 0 - 6 °dH you
do not need to use softening salt and
you can switch off the water softening.
→ "Switch off water softening",
Page 30
Set water softening
Set the appliance to the water
hardness.
Determine the water hardness and
1.
the desired setpoint.
→ "Overview of the water hard-
health settings", page 28
on to press.
2.
Approx. 3 seconds on
3.
to access the basic settings.
a The display shows H:xx
to give.
a The display shows
to give.
Just as often on
4.
the desired water hardness has
been set.
The factory setting is H:04.
To save the settings, press for
5.
approx. 3 seconds.

Softening salt

You can soften the water with
softening salt.
Filling softening salt
If the Refill softener salt indicator
lights up, top up the softener salt in
the softener salt reservoir
immediately before the start of the
programme. The required amount of
softening salt depends on the water
hardness. The higher the
Busy-
reflected
or
press to
Softening System NL
water hardness, the greater the
amount of softening salt required.
PAY ATTENTION!
s Dishwasher detergent can damage the water
damage hardening.
The reservoir of the softener
▶
Only fill the water supply with
special salt for dishwashers.
s The rinse aid container can be
corrode softening salt.
To ensure that
▶
spills softener salt from the
rinse aid container is rinsed, the
softener salt is filled into the
softener salt reservoir
immediately before the program
starts.
Open the lid of the softening salt
1.
reservoir and remove it.
When using for the first time: fill the
2.
reservoir completely with water.
29