Table of Contents
Advertisement
7 October 2021
MANUAL ON/OFF SWITCH
AS SHOWN FROM THE FRONT OF THE BURNER
The switch is located behind the grate on the control valve heat shield as shown above.
Press and release the power button. This will start the electronic spark and the power LED will be on
permanently. The pilot will ignite first and once this is on, it will ignite the main burner. Pressing and
releasing the power button again will switch off the appliance.
When the appliance is turned on, the gas fire will be set to medium flame and fan setting.
If the gas fails to light, the appliance will go into lock out mode. To start the appliance again turn appli-
ance off and wait 3 minutes before turning it on.
Please note that the power button is for use when the remote controller is lost or damaged and can't be
used. This controller can not adjust flame height or fan speed, hence is supplied for emergency use, if
remote and phone App is not able to be used.
27
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
All Dimension are in mm.............Copyright ©
Advertisement
Table of Contents
