HIS -ML12 E Series User Manual page 22

Video Settings
Setup Menu
Source scan
Advanced Setup
22 ML12E User Manual, 99151B, September 2021
Description
Allows the user to turn source scan "On" or "Off." When Source
scan is enabled and there is no active video signal present, the
display will cycle through video connections until a video source
is detected�
The Advanced Setup submenu contains two additional settings:
• Smart ISP flashes the video board firmware. Do not
activate without assistance from Hope Industrial technical
support�
• CVT Mode set to "On" will force the display to only render
VESA CVT standard signals. When set to "Off" (the default
setting) the display will use its entire internal lookup table
when syncing to an incoming video signal. CVT Mode
should only be set to "On" as a troubleshooting step if the
display is having trouble syncing to an analog video signal.