MARIMEX 19000618-9 Series Installation Manual page 64

Step 13
This is what the safety net should look like with the threaded metal ring. It is now
ready for further assembly.
Step 14
Secure the ring holders
to the ends of the Safety
net rod-upper parts - pay
attention to the direction
of the holders. The connec-
ting part for the safety net
ring fastening should be
on the outside.
Step 15
Pull the foam sleeve over
the rod and then the
protective PVC sleeve over
it. The wider opening of
the sleeve should be on
the lower part of the rod
in order to keep accessible
the U-clasps.
Step 16
Screw the upper and lower
parts of the rods together,
pull on the entire foam
sleeves and the protective
PVC sleeves – all rods shou-
ld be covered on the entire
length.
64