MARIMEX 19000618-9 Series Installation Manual page 62

Step 5
Safety net rod – lower parts must be connected to the U-shaped legs using the
added U-clasps. We recommend to fully tighten the pins until the trampoline has
been completely assembled. The protecting foam sleeve will be placed on the rod
above the U-clasp.
Step 6
The jumping mat must be placed with
the cross/logo facing upwards. Always
hook the first four springs to the mat
opposite one another (cross-shape).
This results the even tension of the jum-
ping matt. Place the remaining springs
in place using the same way. CAUTION:
It is essential to use the provided tensi-
oning tools for tensioning the springs
and to pay increased attention to the
protection of your eyes and hands.
Step 7
Once all the springs have been tensio-
ned, your trampoline should look like
on this picture:
62
Step 8
Pull the spring cover over the entire
trampoline circuit so that the springs
are completely covered.