Checking The Rubber Grip - Husqvarna TE 150i 2021 Owner's Manual

12.40

Checking the rubber grip

SERVICE WORK ON THE CHASSIS 12
Main work
–
Check throttle cable routing.
Both throttle cables must be routed, side by side, on the
back of the handlebars, above the fuel tank bracket on the
right of the frame to the throttle valve body. Both throttle
cables must be secured behind the rubber strap of the fuel
tank support.
» If the throttle cable routing is not as specified:
–
Correct throttle cable routing.
H03712-10
Finishing work
–
Install the fuel tank.
–
Install the right side cover. (
–
Mount the seat. (
–
Install the air filter box cover. (
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
401197-01
» If a rubber grip is damaged or worn:
–
Change the rubber grip.
–
Check that screw
Guideline
Screw, fixed
grip
A
Diamond
figure.
V00975-10
( p. 75)
p. 73)
p. 68)
p. 69)
1
is firmly seated.
M4 5 Nm (3.7 lbf ft)
must be positioned visibly as shown in the
®
Loctite 243™
83