Husqvarna TE 150i 2021 Owner's Manual page 93

–
Move the brake fluid reservoir mounted on the handlebar to a
horizontal position.
–
Remove screws
–
Take off cover
H03720-10
–
Manually press the brake caliper toward the brake disc to
push back the brake pistons. Ensure that brake fluid does not
flow out of the brake fluid reservoir, extract some if neces-
sary.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake pis-
tons.
H03721-10
–
Remove cotter pin
–
Push spring plate
–
Remove the brake linings.
–
Clean the brake caliper and the brake caliper bracket.
–
Check that spring plate
7
plate in the brake caliper bracket are seated correctly.
H02377-10
–
Insert the new brake linings.
–
6
Mount pin
Spring plate
Info
Always change the brake linings in pairs.
–
Mount cotter pins
–
Operate the hand brake lever repeatedly until the brake lin-
H03721-11
ings are in contact with the brake disc and there is a pressure
point.
BRAKE SYSTEM 13
1
.
2 3
with membrane .
4
.
5
upwards and remove pin
5
in the brake caliper and sliding
.
5
engages in the groove on the pin.
4
.
6
.
91