Integration Instructions; General; List Of Applicable Rules; Specific Operational Use Conditions - Elatec TWN4 MULTITECH 2 M BLE Integration Manual

3 INTEGRATION INSTRUCTIONS

3.1

GENERAL

TWN4 MultiTech 2 M BLE may be installed in any host devices, as long as it is operated under the operational conditions stated in the
user manual and other technical documents (e.g. data sheet). TWN4 MultiTech 2 M BLE is equipped with two integrated antennas.
Thus, no antenna installation is required.
3.2

LIST OF APPLICABLE RULES

Refer to the approval certificates, grants and declarations of conformity issued for TWN4 MultiTech 2 M BLE, and to Chapter
"Compliance Statements" for a detailed list of the rules applicable to TWN4 MultiTech 2 M BLE.
3.3

SPECIFIC OPERATIONAL USE CONDITIONS

There are no specific operational use conditions for TWN4 MultiTech 2 M BLE other than the conditions mentioned in the user manual
and data sheet of TWN4 MultiTech 2 M BLE. The host manufacturer or integrator must ensure that these use conditions comply with
the use conditions of the host device. In addition, these use conditions must be stated in the user manual of the host device.
3.4

LIMITED MODULE PROCEDURES

n/a
3.5

TRACE ANTENNA DESIGN

n/a
3.6

RF EXPOSURE CONSIDERATIONS

The module antenna(s) must be installed to meet the RF exposure compliance separation distance of 20 cm and any additional testing
and authorization process as required.
Refer to Chapter "Compliance Statements" for detailed information about the radio frequency exposure conditions applicable to
TWN4 MultiTech 2 M BLE.
These RF exposure conditions must be stated in the end-product manual(s) of the host product manufacturer.
3.7

ANTENNAS

TWN4 MultiTech 2 M BLE is equipped with the following antennas:
© 2021 ELATEC GmbH – TWN4 MultiTech 2 M BLE integration manual DocRev2 – 07/2021
TWN4 MultiTech 2 M BLE
Page 4 of 10