Advertisement
Quick Links
ADJUSTABLE
CORNER
BASE CABINET
Fitting
Guide
Adjustable Corner
Cabinet
(Cabinet A)
B
Page 1
FI.PK.FIT.003 - BASE 3
(H) x16 1
" Screws (B) x30
1/4
Screws for attaching to walls and countertop are not provided as these vary
depending on materials, thickness and construction. Ensure appropriate fixings for
wall and countertop construction are used. Please refer to the specialist countertop
supplier if these are required for solid surface countertops.
Packer 1
Adjustable
Corner post
part 1
Step 1.
Secure each leg into place with
"
2 x
screws (B). Ensure legs are
5/8
rotated as shown so that part is
supporting the end panel.
For Internal Use:CON.INS.001.001_50-WKIN00006_BASE3_ADJ_CNR_FITTING_Guide_Rev3
" Screws (K) x2 L Bracket - Large (U) x2 Space-Plug
5/8
Blanking
panel
Packer 2
Adjustable
corner post
part 2
Cabinet B
Advertisement
Related Manuals for Wren Kitchens BASE 3
Summary of Contents for Wren Kitchens BASE 3
- Page 1 ADJUSTABLE FI.PK.FIT.003 - BASE 3 CORNER BASE CABINET (H) x16 1 ” Screws (B) x30 ” Screws (K) x2 L Bracket - Large (U) x2 Space-Plug Fitting Screws for attaching to walls and countertop are not provided as these vary Guide depending on materials, thickness and construction.
- Page 2 ADJUSTABLE CORNER BASE CABINET Fitting Blanking panel Guide Step 2. Cut Blanking panel to required width (refer to customer specific plan) and attach to cabinet face as shown. Packer 1 Step 3. Press packer 1 tightly against the muntin post and screw through the top and bottom of the cabinet using 2 x 1 1/4”...
- Page 3 ADJUSTABLE CORNER Adjustable corner post BASE CABINET part 2 Adjustable Fitting Corner post Guide part 1 Step 5. Front To create your corner post attach face part 1 and part 2 as shown. Rear Screw through part 1 into part 2 at face 4 locations using 4 x appropriately sized screws.
- Page 4 ADJUSTABLE CORNER BASE CABINET Fitting Packer 1 Packer 2 Guide Adjustable corner post part 2 Adjustable Corner post Cabinet A part 1 Blanking panel / 1 6 ” w i d Step 8. Attach adjustable corner post to cabinet A, by screwing through packer 1 at four locations, using 4 x 1 1/4”...