Subscribe to Our Youtube Channel
Related Manuals for Wren Kitchens Vogue BASE UNIT 500 3 Drawer
Summary of Contents for Wren Kitchens Vogue BASE UNIT 500 3 Drawer
- Page 1 BASE UNIT 500 3/4 Drawer Assembly Guide 3 Drawer 4 Drawer For Internal Use: FI.WR.INS.028_WKIN00109_BASE_500_3_4Drawer_Rev6.indd...
- Page 2 BASE UNIT 500 3/4 Drawer Assembly Guide BEFORE YOU START INSTALLATION SHOULD BE PERFORMED BY A COMPETENT PERSON ONLY. THIS PRODUCT COULD BE DANGEROUS IF INCORRECTLY INSTALLED Standard Drawer (Packed Separately) Fitting Pack Contents METAL BACK PANEL (J) x16 (Q) x4 (N) x1 Drawer Runner 21mm...
- Page 3 Step 1. Secure drawer base to drawer side using 4 x 16mm drawer runner screws (J) in holes provided. Seat the edge of drawer base tight Drawer into corner of casing, as shown. base The decorative face of drawer base to be positioned as shown.
- Page 4 BASE UNIT 500 3/4 Drawer Assembly Guide Step 1. Secure drawer base to drawer side using 4 x 16mm drawer runner screws (J) in holes provided. Drawer base Seat the edge of drawer base tight white decorative Metal into corner of casing, as shown. back face up panel...
- Page 5 500 Drawer Unit Contents BEFORE YOU START INSTALLATION SHOULD BE PERFORMED BY A COMPETENT PERSON ONLY. THIS PRODUCT COULD BE DANGEROUS IF INCORRECTLY INSTALLED Panel A Panel B Panel E Panel C x1 Back Panel x2 End Panel x2 Rail Panel x1 Base Panel (F) x12 (G) x8...
- Page 6 BASE UNIT 500 3/4 Drawer Assembly Guide Step 1. To attach drawer runner, screw into end panels (B) using 2 x 16mm screws (J) per drawer rail, into pilot holes provided, 3rd hole from front, as shown. 646mm 360mm 3 drawer 74mm From Bottom 646mm...
- Page 7 Step 2. Step 3. Seat dowel (F) Seat cam dowel (G) into into holes in holes in both end panels (B) Seat (G) cam dowel both end panels (B) as shown. into hole as as shown. shown. Dowel (F) & Cam Dowel (G) location detail Step 4.
- Page 8 BASE UNIT 500 3/4 Drawer Assembly Guide Step 6. Slide back panel (A) into groove of end panels (B). Once back panel (A) is in position, ensure the panel is flush & square with bottom of end panels (B). Step 7. Hand tighten all cam locks (H), this will expand cam dowels (G) and tighten the unit together.
- Page 9 Step 9. Position legs as shown. Ensure legs are rotated to also provide support to the end panels (B). Leg position diagram Step 10. Secure each of the legs into place with 4 x 15mm screws (L) per leg. Step 11. Push leg firmly down into leg base.
- Page 10 BASE UNIT 500 3/4 Drawer Assembly Guide Screws for attaching to walls and worktop are not provided as these vary depending on materials, thickness and construction. Ensure appropriate fixings for wall and worktop construction are used. Please refer to the specialist worktop supplier if these are required for solid surface worktops.
- Page 11 For Internal Use: FI.WR.INS.028_WKIN00109_BASE_500_3_4Drawer_Rev6.indd Page 10...
Need help?
Do you have a question about the Vogue BASE UNIT 500 3 Drawer and is the answer not in the manual?
Questions and answers