Troubleshooting - AEG DCK431110M User Manual

26 www.aeg.com
Step 7
Step 8
Step 9
11.5 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Turn off the oven. Wait until
the oven is cold.
Back lamp
Step 1
Step 2
Step 3
Step 4

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
In any cases not included in this table
please contact with an Authorised
Service Centre.
Clean the glass panel with
water and soap. Dry the
glass panel carefully. Do not
clean the glass panels in
the dishwasher.
After cleaning, do the above
steps in the opposite se‐
quence.
Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise the
surface of the door may overheat.
Before you replace the lamp:
Step 1
Turn the glass cover to remove it.
Clean the glass cover.
Replace the lamp with a suitable 300 °C heat-resistant lamp.
Install the glass cover.
Step 2
Disconnect the oven from
the mains.
Problem
The oven does not
heat up.
The display shows
"12.00".
The lamp does not
work.
Step 3
Put a cloth on the bottom of
the cavity.
Check if...
The fuse is blown.
There was a power
cut. Set the time of
day.
The lamp is burnt
out.