Troubleshooting Tips
If properly maintained, The Kurt DX6 Series vise will operate trouble
free for many years. In some cases, it will be necessary to troubleshoot.
Use the information below to help in the process.
Problem: My vise turns hard.
Tip: As a new vise the brush seal could be stiff. Allow for break in of vise.
Tip: As a used vise, it could be filled with chips and threads could be
jammed. Properly clean and grease vise.
Problem: My vise will not turn in either direction.
Tip: The vise is jammed with debris. Disassemble and clean as needed.
Problem: My vise won't hold tolerance.
Tip: You may be experiencing jaw lift from clamping too high or on one
side of the jaw. Lower the part in the vise jaw and clamp more material.
Problem: My vise is stiff when clamping on a part or is difficult to back
off a part.
Tip: The vises thrust bearing pack may need to be replaced.
Problem: My vise is not clamping at a high clamping force.
Tip: The vises thrust bearing pack may need to be replaced.
TROUBLESHOOTING TIPS
18