Kurt CROSSOVER ANGLOCK VISE DX6 Operating Instructions Manual page 10

SURFACE MOUNT USING SINE KEYS
Mounting the new DX6 with keys requires the use of sine keys instead of
standard keys. They are available in several different sizes that are listed
on our website at www.kurtworkholding.com. The keys are sold in sets of
2 per package.
English Mounting:
The DX6 can be properly located using the four English sine key holes
indicated by the Y's in figure 5 above. The DX6 can be bolted down using
the four 1/2" bolt holes indicated in figure 5 above by NN. The DX6 vise
can also be mounted using both bolt slots on the sides of the vise.
Metric Mounting:
The DX6 can be properly located using the four Metric sine key holes
indicated by the X's in figure 5 above.
PROPER CHIP GUARD INSTALLATION AND USAGE
Table of Contents
Introduction .................................................................................................................3
Fig.6
Setup Instructions......................................................................................................4
Operating Instructions .........................................................................................5-7
DX6 Parts List ...............................................................................................................8
DX6 Mechanical Drawing ........................................................................................9
Maintenance Schedule....................................................................................10-12
Troubleshooting Tips ............................................................................................. 13
CAUTION:
Is used when your action or lack of action may cause serious
CAUTION:
injury.
Chip Guard stock shown above is provided to keep chips from
the nut and screw assembly and must be cut and deburred to
meet your application and safety needs.
Example: Part plus 1 inch = Length of Chip Guard.
Note: Remove Chip Guard
cause injury.
10
stock. If left uncut, the excess material could
OPERATING INSTRUCTIONS