Advertisement
HPCT304G, HPCT365G
Cabinet and Countertop Layout
• To reduce risk of personal injury from reaching over a hot cooktop,
avoid cabinet storage over the cooktop.
• Failure to meet or exceed the maximum and minimum dimensions/
clearances as instructed may cause a fire hazard.
• Follow the countertop manufacturer's instructions regarding all
aspects of countertop installation.
• Carefully check the cooktop installation site. Situate the
cooktop away from drafts and wet areas.
• Use the cooktop with a suitable vent hood or approved Dacor
downdraft.
Installation must allow:
• at least 1/4" (6 mm) clearance between the bottom of the
cooktop chassis and all combustible surfaces, including the
edges and corners of drawers under the cooktop.
• clearance for hold-down brackets
• The gas supply piping, gas shut-off valve, and electrical outlet
must not interfere with the installed cooktop.
• If installing an appliance below the cooktop, allow for routing of
utilities behind it.
• access to the gas shut-off valve and regulator without moving
the cooktop.
• the 40" (101.6 cm) power cord to reach an electrical outlet, and
outlet to be accessable without moving the cooktop.
• access to the cooktop bottom for service/maintenance.(Do not
install fixed shelving below the cooktop.)
All specifications subject to change without notice.
Heritage
Drop-In Gas Cooktop
WARNING
All tolerances: ±¹/₁₆" (±1.6 mm) unless otherwise stated.
30", 36" Wide
®
Model
HPCT304G
HPCT365G
Callout
1
Measured from top of cooktop grate
If installing with an overhead vent hood, also check hood
2
specifications for minimum required clearances.
Not applicable for cabinets more than a horizontal distance
3
of 6" (15.2 cm) from edge of cooktop.
Downdraft Compatibility
If installing the cooktop with a downdraft, use only the approved
Dacor model numbers MRV3015 or MRV3615. (See Pg. 5.)
www.dacor.com
PLANNING
GUIDE
A—Minimum/Maximum
30" (76.2 cm)/36" (91.4 cm)
36" (91.4 cm)/42" (106.7 cm)
Description
Ph. 800.793.0093
Page 4 of 5
Advertisement
