Qube Power Up Procedure - Navman Qube4 Installation Training & Troubleshooting

Qube Power Up Procedure

When the installation is complete, perform the following steps in
the order they are listed to bring the device online promptly
1. Ensure vehicle is outside and has clear view of sky
Diagnostic LED's
2. Attach both antenna cables to the Qube,
Green – Power (On/Off/Sleep)
Orange – GPS (Fix/No Fix)
3. Plug in the power harness,
Red – Cell (Online/Offline)
4. Remove the yellow shipping plug (Qube3),
5. Cycle ignition On/Off 2-3 times, leave ignition On
6. Wait for the three diagnostic LED's to turn On
*If any LED's are not On within 10 minutes, perform Cold Reset
7. Connect optional harnesses: ConEx, M-Nav, MDT
8. Perform Live Test outlined on next page
22 | Confidential