Campbell Hausfeld IN728001AV Easy Setup Manual

2 inch Brad Nailer
CHN70200
Setup
Easy Setup Guide
Projects are easier with
Campbell Hausfeld products.
Thank you for deciding to purchase a
Campbell Hausfeld product. We are dedicated
to providing tools that help you to complete your
projects Like a Pro.
© 2009 Campbell Hausfeld/Scott Fetzer © 2009 Campbell Hausfeld/Scott Fetzer
3
Load
fasteners. See manual for further information regarding length and type
of fasteners.
Press
magazine latch button
and pull magazine open.
Setup Like a Pro
1
Visit us at chpower.com
Close
regulator,
ON
Allow
Like a Pro maximum pressure.
NOTICE: To operate this tool you will need
IN728001AV 6/09
Load Close
nails with points all the magazine.
way into the groove.
2
pressure Attach
Turn hose to regulator
compressor and outlet.
tank to reach regulator knob so
outlet pressure is
between 60 psi and
100 psi.
at least a 1 gallon compressor.
4
Attach
coupler on air
hose to nailer inlet.
air
Adjust
100
60
psi
psi
performing any maintenance or repair, clearing a jam,
loading, unloading, or moving the tool to a new location.
Disconnect the tool from air source. Remove screw
and battery compartment cover. Insert two (2) new
batteries in the proper orientation. Do not mix old
and new batteries. Close cover. Replace screw.
CHN70200 — Air Powered Brad Nailer
Screw
Battery Replacement
Always disconnect the tool from
the power source when unattended,