Axis Q1798-LE User Manual page 21

AXIS Q1798-LE Network Camera
Additional settings
1. Go to System > Events > Action rules.
2. Click Add.
3. Give the action rule a name, for example "Open gate".
4. In the Trigger drop-down menu, select Input signal.
5. Select Digital input signal.
6. Select "PIR detector", in this example connected to port 1.
7. Under Actions, select Output port from the Type drop-down menu.
8. In the Port drop-down menu, select "Gate switch".
9. Click Ok.
10. Create another action rule with the name "Direct the camera to the gate".
11. Select the same input signal as before, but as action select the previously created "Gate entrance" preset position.
12. Click Ok.
Set up the intrusion alarm
Before you start
• Connect the intrusion alarm switch to pin 1 (ground) and pin 3 (digital I/O) of the camera's I/O connector.
Configure the input port
1. Go to Settings > System > I/O ports.
2. For Port 1:
2.1 Select Input in the drop-down menu
2.2 Select Closed circuit (NC) in the drop-down menu
Create a rule
1. Go to Settings > System > Events and create an action rule.
2. Type a name for the action rule.
3. From the Trigger drop-down list, select Input signal and Digital Input Port.
4. Set Active to Yes.
5. From the Schedule drop-down list, select Send Notification and select a recipient or create a new recipient.
To create a new recipient, click . To copy an existing recipient, click
21
.
.
.