Axis Q1798-LE User Manual page 18

AXIS Q1798-LE Network Camera
Additional settings
1. Connect the other end of the ground wire to pin 1 (GND/-).
2. Connect the other end of the power wire to pin 2 (DC input/+).
3. Connect the other end of the I/O wire to pin 3 (I/O output).
Configure the I/O port in the camera's webpage
1. Go to Settings > System > I/O ports.
2. Select Input in the Port 1 drop-down list.
3. Give the input module a descriptive name.
4. To make the PIR detector send a signal to the camera when it senses motion, select Closed circuit in the drop-down list.
To trigger the camera to start recording when it receives a signal from the PIR detector, you need to create an action rule in
the camera's webpage.
Record video when the camera detects loud noises
This example explains how to set up the camera to start recording to the SD card five seconds before it detects loud noise and to
stop one minute after.
Note
The following instructions require that a microphone is connected to audio-in.
Turn on audio:
1. Set up the stream profile to include audio, see Add audio to your recording on page 22.
Set up audio detection:
2. Go to Settings > System > Detectors > Audio detection.
3. Adjust the alarm level according to your needs.
Create a rule:
4. Go to Settings > System > Events and add a rule.
5. Type a name for the rule.
6. In the list of triggers, select Detectors and then select Audio Detection.
7. In the list of actions, select Record video.
8. Select the stream profile where audio has been turned on or create a new one.
9. Enable and set the pre-trigger time to 5 seconds.
10. Enable While the rule is active.
11. Enable and set the post-trigger time to 60 seconds.
12. Select SD card from the list of storage options.
13. Click OK.
18