Axis Q1798-LE User Manual page 20

AXIS Q1798-LE Network Camera
Additional settings
8. In the list of actions, select Output port, and then select the port the AXIS I/O Indication LED is connected to. Set the
state toActive and set duration as required.
9. Save the rule.
Other scenarios where AXIS I/O Indication LED can be used are for example:
• Configure the LED to turn on when the camera starts, to indicate the presence of the camera. Select System ready as
a condition.
• Configure the LED to turn on when live stream is active to indicate that a person or a program is accessing a stream from
the camera. Select Live stream accessed as a condition.
Configure I/O ports
You need to connect the switch relay to the camera from the camera's webpage. First, configure the I/O ports:
Set the PIR detector to an input port
1. Go to System > I/O ports.
2. Select Input in the Port 1 drop-down list.
3. Give the input module a descriptive name, for example "PIR detector".
4. To trigger an event whenever the PIR detector senses motion, select Open circuit in the drop-down
list.
Set the switch relay to an output port
1. Go to System > I/O ports.
2. Select Output in the Port 2 drop-down list.
3. Give the output module a descriptive name, for example "Gate switch".
4. To open the gate whenever an event is triggered, select Closed circuit in the drop-down list.
Create rules
For the camera to open the gate when the PIR detector senses someone nearby, you need to create a rule in the camera:
20