Hyundai HR3302E Original Operation Instructions page 24

• Warning! Be careful during unpacking
and do not touch the sharp blades at the
bottom of the lawn mower.
Assembly (Image D)
D1: Insert the two rods of the lower
handlebar into the corresponding holes in
the housing of the device until you here a
click sound. You can adjust the height of
the handlebar at any time by pressing the
button and inserting the rods deeper or less
deep. Three positions are possible. Make
sure that the rods are inserted up to the
click each time. Only then are they properly
fixed.
D2: Attach the upper handlebar to the rods
of the lower handlebar as shown in the
image.
D3: Fix the power cable to the handlebar
with the cable clips. Make sure that the
cable stays away from moving components
and has enough space.
D4: Lift the impact protection and hang up
the grass basket. Caution! The device
must not be used without the grass
basket.
Operation (Image E)
E1: Plug the power plug into the socket.
Pay strict attention to the safety
instructions in this manual. To obtain a
strain relief of the cable, fix the power cable
as shown in the image.
E2: To start the device, hold down the
safety button and pull the engine lever.
After starting the device, you can release
the safety button.
E3: Release the engine shift lever. The
engine turns off. Caution! After releasing
the engine lever, the blade keeps
moving for a few seconds. Be sure to
wait until the engine and the blade have
come to a complete standstill before
transporting the device or performing
any work on the device.
E4: The device is equipped with a central
5-step height adjustment which allows you
to adjust the lawn height between 25 and
65 mm.
E5: To adjust the height, pull the handle of
the height adjustment slightly to the side
and move it to the desired position. The
height adjustment may only be carried
out with a completely switched off
device!
E6: The lawn mower has a fill level
indicator. If the grass catcher is not full, the
flap of the indicator stays open and air
comes out.
E7: If the grass catcher is full, the air flow is
disrupted and the flap closes. If this
happens, the grass catcher needs to be
emptied. To empty it, turn off the lawn
mower and make sure that the blade is
not moving any more.
Tips for Mowing
• It is possible to adjust the lawn height to
a height between 25 and 65 mm on the
lawn mower. To have the optimal lawn,
we recommend using the medium cutting
height between 30 and 50 mm.
• When the grass is too high, we
recommend mowing in different stages.
This means to start with maximum
cutting height and then set it to the
desired cutting height in the second or
third pass.
• Try to mow in straight lines if possible.
The lines should overlap at several
centimeters.
• Always start with the mowing at the edge
of the lawn that is closest to the socket.
Move the device away from the socket so
that the cable always lies on the already
mowed lawn surface. Be careful when
turning the device.
EN 24