Preparing The Mower For Transport - SaMASZ KDT 180 Operator's Manual

S
A
Fig. 9. Connecting the mower to the tractor.
CAUTION:
Before disconnecting the mower put the pin 1 (Fig. 10a) into the hole 3
in the bar (Fig. 10a) to secure the linkage against falling. When the
mower is connected the pin should be in the bush 2 (Fig. 10a) on the
middle bar.

5.2. Preparing the mower for transport

To prepare the mower for transport and to meet safety precautions, please do the following:
lift the mower with tractor hydraulic lift until the lower lift pins of the mower 3-point linkage
frame raise about 50 cm above the ground (Fig. 12),
remove the pin 1 and put it into the bush 2 (Fig. 10a),
lift the cutterbar by hydraulic cylinder vertically until the pawl Z locks in (Fig. 10b),
secure the cutterbar against falling by the shut-off valve (Fig. 11b.) placed on the mower's
hydraulic cylinder.
CAUTION:
During transport the shut-off valve of mower hydraulic lift should always
be closed – the valve lever in Z position (Fig. 11). It protects the mower
against incidental falling in case of hydraulic failure.
O
a
Fig 11. Shut-off valve position: a) open(work), b) closed(transport).
Operator's manual
L
W
A
- 18 -
Rear disc mowers
KDT 180;KDT 220 S/W;KDT 260 S/W;
KDT 300;KDT 340
1
2
3
Z
Fig. 10 a) 1 - pin, 2 - bush, 3 – hole in the bar
b) Z - lock.
b
a
b
Z