Preparation - Lenze g500-S Series Mounting And Switch-On Instructions

Preparation

Protect shaft sealing rings from contact with solvents.
•
Remove protection covers from shafts.
•
Thoroughly remove anticorrosion agents from the shaft and from flange faces.
•
Draw the transmission elements onto the output shaft only by using the centering thread.
•
Align the output shaft and transmission elements exactly to avoid tensions.
•
Mount belt pulleys, sprockets, or gear wheels as close as possible to the shaft shoulder in
•
order to keep the bending load of the shaft and the bearing forces at a minimum level.
Tighten all screw connections with the specified torques and secure them with standard
•
screw locking adhesive.
Check paint for damage and repair professionally.
•
Thread M3
Strength
4.8 Nm 0.7
8.8 Nm 1.3
10.9 Nm 1.9
M4 M5 M6 M8
Tightening torque Nm ±10 %
1.4 2.8 4.8 12
3.0 5.9 10.1 24.6
4.6 8.6 14.9 36.1
Mechanical installation
M10 M12 M16 M20
23 − − −
48 84 206 415
71 123 302 592
Preparation
M24 M27 M30
− − −
714 1050 1428
1017 1496 2033
21