Preparation - Lenze m550-H-P63 80 Series Mounting And Switch-On Instructions

Thread
Load carrying kg
capacity

Preparation

Protect shaft sealing rings from contact with solvents.
•
Remove protection covers from shafts.
•
Thoroughly remove anticorrosion agents from the shaft and from flange faces.
•
Draw the transmission elements onto the output shaft only by using the centering thread.
•
Align the output shaft and transmission elements exactly to avoid tensions.
•
Mount belt pulleys, sprockets, or gear wheels as close as possible to the shaft shoulder in
•
order to keep the bending load of the shaft and the bearing forces at a minimum level.
Tighten all screw connections with the specified torques and secure them with standard
•
screw locking adhesive.
Check paint for damage and repair professionally.
•
Thread M3
Strength
4.8 Nm 0.7
8.8 Nm 1.3
10.9 Nm 1.9
M6 M8 M10
80 140 230
M4 M5 M6
1.4 2.8 4.8
3.0 5.9 10.1
4.6 8.6 14.9
Mechanical installation
M12 M16
340 700
M8 M10 M12 M16
Tightening torque Nm ±10 %
12 23 − −
24.6 48 84 206
36.1 71 123 302
Preparation
M20 M24
1200 1800
M20 M24 M27 M30
− − − −
415 714 1050 1428
592 1017 1496 2033
21