Cleaning; Faults - UNITED OFFICE UAV 190 B2 Operating Instructions Manual

Cleaning

► Always pull out the plug before cleaning the appliance . There is a risk of
electric shock!
► The cutters in the appliance are very sharp! Risk of injury!
CAUTION! MATERIAL DAMAGE!
● Remove any residue left in the cutting opening 2 or cutting blades with a
suitable tool, e .g . a pair of tweezers . Ensure that the appliance is unplugged
before doing this!
● Clean the appliance with a moist cloth . For stubborn dirt, add a little mild
detergent to the cloth .

Faults

If the paper jams:
This means that you have attempted to feed too much paper into the appliance
(max . 6 sheets 80 g /m
● Move the switch 1 into the "REV" position if the paper causes a blockage .
The appliance now goes into reverse and the material that is being shredded
is ejected .
● Pull the paper out of the appliance and then set the switch 1 to "AUTO" .
● The appliance is now ready for use .
If the appliance suddenly stops working:
This means that the appliance is overheated and the automatic safety cut-out has
activated itself . The overheat LED 5 lights up red .
► Remove the power plug from the wall socket to avoid unintended restarting
of the appliance .
● Place the switch 1 in the "OFF" position .
● Allow the appliance to cool until it has cooled to room temperature .
● Put the mains plug back into the socket .
● Switch the appliance on by moving the switch 1 into the "AUTO" position .
UAV 190 B2
DANGER – ELECTRIC SHOCK!
WARNING – RISK OF INJURY!
Do not spray any oil or other lubricants into the cutter opening 2 .
These can irreparably damage the appliance .
paper) .
2
WARNING – RISK OF INJURY!
│ 17 ■
GB │ IE