Cleaning; Faults - UNITED OFFICE UAV 190 B2 Operating Instructions Manual

Cleaning

► Always pull out the plug before cleaning the appliance. There is a risk of
electric shock!
► The cutters in the appliance are very sharp! Risk of injury!
CAUTION! MATERIAL DAMAGE!
Remove any residue left in the cutting opening 2 or cutting blades with a
●
suitable tool, e.g. a pair of tweezers. Ensure that the appliance is unplugged
before doing this!
● Clean the appliance with a moist cloth. For stubborn dirt, add a little mild
detergent to the cloth.

Faults

If the paper jams:
This means that you have attempted to feed too much paper into the appliance
(max. 6 sheets 80 g /m
Move the switch 1 into the "REV" position if the paper causes a blockage.
●
The appliance now goes into reverse and the material that is being shredded
is ejected.
Pull the paper out of the appliance and then set the switch 1 to "AUTO".
●
● The appliance is now ready for use.
If the appliance suddenly stops working:
This means that the appliance is overheated and the automatic safety cut-out has
activated itself. The overheat LED 5 lights up red.
► Remove the power plug from the wall socket to avoid unintended restarting
of the appliance.
Place the switch 1 in the "OFF" position.
●
● Empty the container.
● Allow the appliance to cool until it has cooled to room temperature.
● Put the mains plug back into the socket.
Switch the appliance on by moving the switch 1 into the "AUTO" position.
●
UAV 190 B2
DANGER – ELECTRIC SHOCK!
WARNING – RISK OF INJURY!
Do not spray any oil or other lubricants into the cutter opening 2.
These can irreparably damage the appliance.
2 paper).
WARNING – RISK OF INJURY!
GB │ IE
│
7 ■