Table of Contents
Advertisement
FabiaTech Corporation
5. Select the Disabled or Enabled.
Enabled: System will ask input password on post time.
Disabled: System will ask input password on post time. When go to BIOS setup.
6. Point to Save Settings and Exit and press Enter. (or Press F10)
7. Press Y when you see the message, "Exit Saving Changes (Y/N)?"
Note: it is suggested that you write down the password in a safe place to avoid
that password may be forgotten or missing.
How to Clean User Password
Select Clear User Password from the Security menu and press <Enter>.
Clear New Password > [Yes] [No] appears, select [Yes] and press <Enter>.
How to Clear Supervisor Password
Select Supervisor Password from the Security menu and press <Enter>. "Please Type
in you password" >, type the password (Old password) and press <Enter>. The
screen does not display the characters entered. Retype the password as prompted
and press <Enter>.
Power on Password
This field enables password checking every time the computer is powered on or
every time the BIOS Setup is executed. If Enabled is chosen, a user password
prompt appears every time and the BIOS Setup Program executes and the
computer is turned on. If Disabled are chosen, the password prompt appears if the
BIOS executed.
Available options: Enabled, Disabled
Default setting: Disabled
User Access Level
This field is Supervisor set the user can view only or full the BIOS Setup is executed. If
"View only" is chosen, a user only access to CMOS setup allowed buts the fields
can't be change. If "Limited" is chosen, only limited can be changed, if "Full" is
chosen, any field can be changed except the Supervisor password.
Available options: View Only, Limited, and Full
Default setting: Full
45
Advertisement
Table of Contents
