Table of Contents
Advertisement
FabiaTech Corporation
Security setup
There are two security passwords: Supervisor and User. Supervisor a privileged
person that can change the User password from the BIOS, According to the
default setting, both access passwords are not set up and are only valid after you
set the password from the BIOS.
• Set Supervisor Password
• Set User Password
• Power on Password
• User Access Level
To set the password, please complete the following steps.
1. Select Set Supervisor Password.
2. Type the desired password (up to 6 character length) when you see the
message, "Please type in you new Password" and "Please confirm you new
password".
3. Then you can go on to set a "Set User Password" (up to 6 character length) if
required. Note that you cannot configure the User password until the
Supervisor password is set up.
4. Enter "Power on Password", when you Supervisor password are set up.
44
Advertisement
Table of Contents
