Table of Contents
Advertisement
1.28
FORWARD TRAVEL SPEED BACKSTOP LEVER
The backstop lever can be used to limit the movement of the for-
ward pedal for accurate forward travel speed, and the clip rate
required.
Operate the lever in a forward direction to increase the travel speed
setting (refer fig.1.) and in a rearward direction to decrease (refer
fig.2.).
Note: This is not a cruise control device. Releasing the forward
travel pedal will allow it to return to neutral.
SPEED CONTROL PEDAL
WARNING : PREVENT ACCIDENTS - Enure that the control cable is securely fastened to the speed
control pedal mechanism. Ensure that both the cable and pedals articulate freely through the fuel range
of travel and that the mechanism freely returns to neutral when released.
Forward travel: Depress the forward travel pedal to increase forward travel speed.
Release the pedal to reduce speed.
Reverse travel: Depress the reverse travel pedal to increase reverse travel speed. Release
the pedal to reduce speed.
Stop (Neutral): Release the forward or reverse travel pedal.
TRANSPORT LATCHES
WARNING : PREVENT ACCIDENTS - ALWAYS raise the
cutterheads to the transport position and secure with the trans-
port latches and safety locks when travelling between work
areas.
Front cutterhead transport latches:
Centre cutterhead transport latch:
OPERATING THE MOWER
Fig. 1
Fig. 2
1
2
1
1. Transport latch.
2. Safety lock.
1.28
1
2
2
111-0467CR201205
Advertisement
Table of Contents
