Every 500 Hours - Hayter MT313 Operator's Manual

1.51

EVERY 500 HOURS

Perform routine checks : refer
Thoroughly clean the machine:
IMPORTANT: PREVENT DAMAGE - Keep water away from electrical components. Use a dry
cloth or brush to clean such areas.
Service the hydraulic system : This procedure is best carried out when
the hydraulic oil is warm (not hot). Lower the cutterheads to the ground
and drain the hydraulic system. Remove the hydraulic oil tank filler flange
(1) to gain access to the suction strainer. Unscrew and suction strainer (2)
the strainer and clean with paraffin or petrol before replacing. Renew the
strainer if there are any signs of damage.
Remove the oil filler cap strainer and clean before replacing. Renew the
strainer if there are any signs of damage.
Renew the return line oil filter element, refer - RUNNING IN PERIOD
AT FIRST 50 HOURS.
Renew the transmission oil filter element, refer - RUNNING IN PERIOD
AT FIRST 50 HOURS.
Run the machine and operate all hydraulic systems until the hydraulic oil
is warm. Recheck the oil level and top up as necessary to the upper mark
on the sight level gauge.
MAINTENANCE
- DAILY BEFORE USE.
- EVERY 50 HOURS.
- EVERY 250 HOURS.
1.51
1. Oil Tank Filler Flange
2. Suction Strainer
3. Hydraulic Oil Filler Cap
4. Filter / Strainer
5. Hydraulic Oil Filler Cap Base
2
3
4
5
111-0467CR201205
1