Installer Setting - Test Run Mode - LG ABNQ18GM1T0 Installation Manual

Installer Setting - Test Run Mode

After installing the product, you must run a Test Run mode.
For details related to this operation, refer to the product manual.
FAN
SPEED
TEMP
What is the test run mode?
- This means the operation of the product under the cooling, strong wind, and Comp on state
without performing room temperature control in order to confirm the installed state during the
product installation.
1
2
3
OPER
MODE
4
INSTALLATION INSTRUCTION
When pressing the
button simultaneously for more than 3
seconds, the system will be entered
into the installer setting mode.
- After entering into the installer setting
mode, select the test run mode code
value by pressing the
* Test run mode code value : 01
When pressing the OPER
MODE
operation mode will be performed, and it
is displayed as shown in the left figure.
When pressing the
button simultaneously for more than 3
seconds after the setting has been
completed, the setting mode will be
released.
- If there isn't any button input for
more than 25 seconds, the installer
setting mode will also be released.
When approx. 18 minutes are elapsed
after starting of the test oper-mode, the
system will be stopped automatically
and converted to the standby state.
- If any button is inputted during the
test run mode, the test run mode will
be forced to be relreased.
21
OPER
button and
MODE
button.
OPER
MODE
button, the test
OPER
button and
MODE