Related Manuals for Midea ECOHEAT Series
Summary of Contents for Midea ECOHEAT Series
- Page 1 USER’S MANUAL Water Heater ECOHEAT SERIES Rated Voltage: 230V Rated Power: 3800W Frequency: 60Hz Weight: 1.6kg Dimensions (WxHxD): 224x330x93mm FP-67WTR380WMTL-W1 version 000 ph.midea.com...
-
Page 2: Table Of Contents
Sincerely, thank you for selecting our electric water heater. Please read this manual carefully before use; correctly grasp the methods for installation and use of this electrical water heater, to make full use of its superior performance. Please do preserve the instruction manual, for future reference. -
Page 3: Caution
1. CAUTION To prevent personal injury, injury to others and property damage, the instructions below must be followed. Incorrect operation due to failure to follow instructions will cause harm or damage. Special Caution This water heater is for household use only and it can be installed indoors where hot water is needed. -
Page 4: Product Introduction
WARNING The water heater should be earthed before use. Please ensure that the resistance of household earth wire is <4Ω. Using water heater without earthing is highly prohibited. 2. PRODUCT INTRODUCTION 2.1 Technical Specifications Model FP-67WTR380WMTL-W1 Rated Voltage 230V~ Rated Frequency 60Hz Rated Power 3800W... - Page 5 2.2 Parts Identification Temperature Terminal block Wire pressing board Limiter/ Thermal cut out Heating Main control board elements assembly Indicator light board Stainless steel circlip Electronic Silicon control Temperature sensor Flow sensor Marker for Marker for wateroutlet water inlet Blue Key board Water outlet Water inlet...
-
Page 6: Unit Installation
3. UNIT INSTALLATION 3.1 Installation Instruction ① Check the capacity of power circuit (circuit breaker, wires, etc.) ② Power cord installation; ③ Water heater installation; ④ Plumbing connection; ⑤ Power supply connection; ⑥ Water Supply. 3.2 Power Cord Installation Step 1 Step 2 Remove the screws at the bottom of the unit. - Page 7 NOTE The installation position of neutral line (blue), live line (brown/red) and earth line (green/yellow) should be corresponding to the other end of the wiring terminals. 3.3 Water Heater Installation ① Determine installation position of the unit according to length of power cord / position of circuit breaker (Distance between bottom and floor should be ≥1.6m).
- Page 8 Water flow adjusting valve with filter Cold water inlet (Fig.2) NOTE Water flow adjusting valve with filter must be used when installing the unit. Blue marker stands for water inlet, red marker stands for water outlet. Do not apply excessive torque/force to avoid damaging the water heater.
-
Page 9: Usage
4. USAGE 4.1 Operating the unit Switch on the power supply, the unit will conduct a self-inspection for 2 seconds. ELCB green indicator light will turn on (If there is no current leakage). Rotate the knob clockwise to switch on the unit and the indicator ELCB light will turn on. -
Page 10: Maintenance
5. MAINTENANCE This electric water heater should be installed in a place without direct sunshine or where rainwater will not hit the unit. Please cut off power supply if the unit will not be used for a long period of time. Please run the water for about 10 seconds to drain away the impurities in the pipe before connecting the water source to the electric water heater, to avoid clogging. -
Page 11: Troubleshooting
6. TROUBLESHOOTING SYMPTOMS REASONS SUGGESTIONS 1. Power supply error; 1. Check whether power Switch on the power 2. PCB error; is cut. supply, ELCB indicator 3. Thermal cut out is 2. Contact authorized light is off. activated service personnel for repair. - Page 12 A quality product of Customer Care www.midea.com.ph Email: customercare@midea.com.ph For more information, please visit our website Toll free: 1-800-10-863-5522 Landline: (02) 863-55-22 Viber/SMS: (0917) 863-5522 Monday - Sunday / 8:00am - 8:00pm...