Graco G-Mini 25R800 Instructions Manual page 24

Controller Operation
- OF (OFF) - Select OF to con-
figure the controller to not
require a PIN code. Press the
ENTER button again to set
the OF (OFF) option.
3. The first digit on the display
begins to blink. This confirms
that the controller is ready to
select the first number of the PIN
Code.
4. Press the UP or Down
arrows to select the first
digit.
5. Press the ENTER button to save the
selection.
After the ENTER button is pressed,
the second digit begins to blink.
This confirms that the second digit for
the PIN Code is ready to be config-
ured.
6. Press the UP or Down
arrows to select the sec-
ond digit.
7. Press the ENTER button to save the
selection.
8. The controller automatically advances to the A2
screen.
24
Entering a PIN Code in the Controller
After the controller is configured for PIN entry, to access
SETUP MODE:
1. Follow Steps 1 and 2 of ADVANCED PROGRAM-
MING, (page 23).
2. Pn appears on the display.
3. Press the ENTER button to
advance the display.
4. The first digit on the display
begins to blink. This confirms
that the controller is ready for the
first number of the PIN Code to
be entered.
5. Press the UP or Down
arrows until the first digit
of the PIN Code dis-
plays.
6. Press the ENTER button to save the
entry.
7. After pressing the ENTER but-
ton, the second digit begins to
blink. This confirms that the con-
troller is ready for the second
number of the PIN Code to be
entered.
8. Press the UP or Down
arrows until the second
digit of the PIN Code dis-
plays.
9. Press the ENTER button to save the
entry.
10. The ON TIME configuration screen displays. See
SETUP MODE, ON TIME Configuration (Min-
utes), page 21 for additional information.
3A6714C