Wiring Dc Power Inputs - Planet IGS-6325 Series Quick Installation Manual

3. Wiring DC Power Inputs

The 6-contact terminal block connector on the panel of Industrial Managed Switch
is used for two DC redundant power inputs. Please use the correct DC input
voltage and follow the steps below to insert the power wires.
1. Insert positive and negative DC power wires into contacts 1 and 2 for DC
POWER 1, or 5 and 6 for DC POWER 2.
Figure 3-1: 6-contact terminal block connector of IGS-6325-20T4C4X and IGS-6325-20S4C4X
Figure 3-2: 6-contact terminal block connector of IGS-6325-24P4X and IGS-6325-24P4S
2. Tighten the wire-clamp screws for preventing the wires from loosening.
Figure 3-3: The pins of 6-contact terminal block connector
The wire gauge for the terminal block should be in the range
between 12 and 24 AWG.
Note
DC POWER
ON
DC 1 Fault DC 2
Input DC 48-56V
DC 1 Fault
+
1 2 3 4
Power 1 Fault
+ -
Ring DI/DO
Fault
DC 2
AC DC 1
DC 2
+
5 6
Power 2
+ -
5