Wiring Dc Power Inputs - Planet MGSD-10080F Quick Installation Manual

3. Wiring DC Power Inputs

The 6-contact terminal block connector on the rear panel of MGSD-10080F is used
for two DC redundant powers input. Please follow the steps below to insert the
power wire.
1. Insert positive / negative DC power wires into the contacts 1 and 2 for DC
POWER 1, or 5 and 6 for DC POWER 2.
2. Tighten the wire-clamp screws for preventing the wires from loosing.
The wire gauge for the terminal block should be in the range of 12
~ 24 AWG.
Note
ON 100~240V AC
DC POWER
OFF
DC Input Range 36V~72V
OFF 50/60 Hz
1 2 3
DC 1
Fault Alarm
+ -
1 2 3 4 5 6
ON
DI 0 DI 1 DO 0 DO 1 GND GND
1 2 3 4 5 6
V1+ V2+
DC 1 Fault DC 2
4 5 6
DC 2
+ -
5