Steps
1. Align the screw holes on the speakers with the screw holes on the display-assembly base.
2. Replace the six screws (M3 4+7.1xZN) to secure the speakers to the display-assembly base.
3. Route the speaker cable through the routing guide on display-assembly base and connect the speaker cable to the system board.
Next steps
1. Install the
rear-I/O
bracket.
2. Install the
bottom
cover.
3. Install the
system-board
4. Install the
back cover
5. Install the
cable cover
(optional).
6. Install the stand.
7. Follow the procedure in
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in
70
Removing and installing components
shield.
After working inside your
computer.
Before working inside your
computer.