Table of Contents
Advertisement
Steps
1. Align the screw holes on the system board with the screw holes on the display-assembly base.
2. Replace the nine screws (M3x5) to secure the system board to the display-assembly base.
3. Connect the camera cable to the connector on the system board.
4. Connect the touchscreen cable to the connector on the system board.
5. Connect the system fan cable to the connector on the system board.
6. Connect the microphone-module cable to the connector on the system board.
7. Connect the SIO-signal cable to the connector on the system board.
8. Connect the speaker cable to the connector on the system board.
9. Connect the audio-board cable to the connector on the system board.
10. Connect the SIO-power cable to the connector on the system board.
11. Connect the display cable to the connector on the system board.
12. Connect the power-button board cable to the system board and close the latch to secure the cable.
13. Connect the display back-light cable to the connector on the system board.
14. Connect the PSU-fan cable to the system board.
15. Connect the PSU cable to the system board.
Next steps
1. Install the
rear-I/O
bracket.
2. Install the
bottom
cover.
3. Install the coin-cell.
4. Install the processor.
5. Install the heat-sink.
6. Install the
M.2 2230 solid-state drive/Intel
7. Install the
M.2 2230 solid-state
8. Install the
hard
drive.
9. Install the
wireless
card.
10. Install the
memory
module.
11. Install the
system-board
12. Install the
back cover
13. Install the
cable cover
(optional).
14. Install the stand.
15. Follow the procedure in
NOTE:
Your computer's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
NOTE:
Replacing the system board removes any changes you have made to the BIOS using the BIOS setup program.
You must make the appropriate changes again after you replace the system board.
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
cable cover
4. Remove the
back
cover.
5. Remove the
system-board
6. Remove the
bottom
cover.
7. Remove the
rear-I/O
bracket.
68
Removing and installing components
Optane.
drive.
shield.
After working inside your
computer.
Before working inside your
(optional).
shield.
computer.
Advertisement
Table of Contents
