Table of Contents
Advertisement
Configuring Physical Interfaces
The network connection supports leased-line service with a BRI S/T interface via an
8-position unkeyed modular jack that is connected to an external NT1.
The data port interface supports three different port types: EIA-530, V.35 and X.21. If
your application does not use a V.35 interface, then the Port Type setting needs to be
changed. The port type is specified in the physical configuration options.
To configure the physical interfaces:
1. Select the Network physical configuration options.
Main Menu → Configuration → Network → Physical
2. Select the appropriate Port Type.
3. Press Ctrl-a and Save your change(s).
4. Return to the Configuration Edit/Display menu.
5. Repeat Steps 2 through 4 for the data port.
Main Menu → Configuration → Data Ports → Physical
6. Return to the Configuration Edit/Display menu.
Setting Up Local Management at the Central Site
1. Create a DLCI for the data port.
Configuration → Data Ports → DLCI Records
2. Save the configuration.
3. Create a Management PVC using the data port DLCI just created.
Configuration → Management and Communication → Management PVC
Minimally, enter the following options:
– Name for the management PVC
– Interface IP Address and Subnet Mask, if different from the Node's
– Primary Link for this Management PVC (the user data port)
– Primary DLCI (i.e., the data port DLCI)
4. Save the configuration.
9
Advertisement
Table of Contents
