Entering Identity Information; Selecting A Configuration Method; Configuring The Unit Using The Configuration Menus - Paradyne Hotwire 7995 Installation Instructions Manual

Entering Identity Information

After accessing your unit for the first time, use the Change Identity screen to determine
SNMP administrative system information that will be displayed on the Identity screen of
the Status branch. To access the Identity screen, follow this menu selection sequence:
Main Menu

Selecting a Configuration Method

You can make configuration changes either through a VT100-compatible terminal and
the unit's Configuration menus or by manually changing switches on the board. The unit
is shipped with the switchpacks disabled to allow settings to be made through the
Configuration menus. See the User's Guide for detailed information about the
configuration options and switch settings.

Configuring the Unit Using the Configuration Menus

Use the Configuration menu to select, display, or change configuration option settings.
NOTE:
The Hotwire 799x endpoint is shipped configured as an STU-R. If using this unit as
an STU-R, the configuration options may not need to be altered.
The unit has two sets of configuration option settings:
T
The Current Configuration: The unit's active set of configuration options.
T
The Default Factory Configuration: A read-only configuration area containing the
factory default configuration options.
Control Change Identity
8