Avaya 5900 Series Installing Manual page 60

Switch installation
Table 16: Status LED descriptions
LED
Base
Status
Up/Down
September 2017
State
Off
Amber (Solid)
Amber (Blinking)
Amber (Fast Flashing)
Emerald (Solid)
Emerald (Blinking)
Off
Amber (Solid)
Amber (Blinking)
Emerald (Solid)
Emerald (Blinking)
Off
Amber (Solid)
Emerald (Solid)
Emerald (Blinking)
Installing Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
Description
The unit is operating in stand-alone mode. If
in a Stack, the switch is not a Base unit or a
Temporary Base unit.
The unit is operating as the Temporary Base
unit.
The unit has a Base unit election problem.
Multiple units are configured with a Base unit
switch on, or no unit has the Base unit switch
on.
The unit did not join the Stack. Refer to the
log for more information.
The unit is operating as the Base unit in a
Stack.
The unit joined the Stack and Automatic Unit
Replacement is upgrading the diagnostics,
agent, or configuration file.
The unit is not operating.
The unit encountered an error during
diagnostics.
The unit is booting. During boot the unit
executes the boot loader and diagnostics.
The unit is operating normally. Agent
software is loaded.
The unit is loading the agent software.
A Cascade Up or Down cable is not detected
or connected to an adjacent unit.
A Cascade Up or Down cable is detected
and connected to an adjacent unit, but
adjacency with the neighbor is not complete.
A Cascade Up or Down cable is detected
and connected to an adjacent unit.
Adjacency with the neighbor is complete.
The unit formed a partial neighbor with an
adjacent unit. Check the Cascade Up and
Down cable connections.
Note:
If rear port mode is enabled, both Up
and Down LEDs blink Emerald in
synchronization. The Base LED is off.
Table continues...
60