Ercol Teramo 2680 Instruction Manual

Double/kingsize beds

ercol

teramo bed

2680/1double/kingsize beds

Thank you for purchasing this teramo bed Please read the instructions carefully before use to ensure safe

and satisfactory operation of this product.

This item is HEAVY

Necessary Tools

Pre-assembly preparation

Please ensure instructions are read in full before attempting to assemble this product

Please check the pack contents before attempting to assemble this product. A full checklist of components

is given in this leaflet. If any components are missing, please contact the retailer from whom you bought

this product.

This product is HEAVY, it should be assembled as near as possible to the point of use. TAKE CARE

WHEN LIFTING to avoid personal injury and (or) damage to the product.

This product takes approximately 30 MINUTES to assemble with 2 PEOPLE.

The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG

CHILDREN.

Table of Contents

Do you have a question about the Teramo 2680 and is the answer not in the manual?

Page 1 2680/1double/kingsize beds Thank you for purchasing this teramo bed Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. This item is HEAVY Necessary Tools Pre-assembly preparation Please ensure instructions are read in full before attempting to assemble this product Please check the pack contents before attempting to assemble this product.
Page 2 Fittings and parts checklist Headboard x 1 Half moon washer Footboard x 1 Side rails x 2 Spanner x 1 Centre rail x 1 Central brackets x 2 Slats double bed x 32 Washers x 2 Slats king size x 34 Ends for slats double x 64 Nuts and bolts x 2 each Ends for slats king size x 68...
Page 3 Step by step assembly instructions 1. Push the threads G into the headboard and the footboard as shown below. Tighten the threads by hand ensuring that there is approximately half of the threads still showing. 2. Making sure the holes in the side rails,C, are facing upwards, AND you have the Left and Right rails, (see page 2) on the corret sides, locate these side rails onto the protruding threads on the headboard and foot board.
Page 4 5. Push a plastic cap onto each end of a slat and with the peg facing downwards push the slat into the pre drilled holes as shown below. Repeat for all the slats. PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE Ercol Furniture Ltd, Summerleys Road, Princes Risborough, Buckinghamshire. HP27 9PX www.ercol.com...

Teramo 2681