Inspection - MULTIQUIP WT5C Operation Manual

Water trailers (honda gx120ut2px2 gasoline engine) (qp2hlf centrifugal pump)
Hide thumbs Also See for WT5C:
Table of Contents

Advertisement

ENGINE OIL CHECK
1. To check the engine oil level, place the unit on secure
level ground with the engine stopped.
2. Remove the filler dipstick from the engine oil filler hole
(Figure 4) and wipe it clean.
Figure 4. Engine Oil Dipstick (Removal)
3. Insert and remove the dipstick without screwing it into
the filler neck. Check the oil level shown on the dipstick.
4. If the oil level is low (Figure 5), fill to the edge of the
oil filler hole with the recommended oil type (Table 4).
Maximum oil capacity is 0.63 quarts (0.6 liters).
NOTICE
Refer to engine manufacturer's manual for specific
servicing instructions.
LOWER LIMIT
Figure 5. Engine Oil Dipstick (Oil Level)
Table 4. Oil Type
Season
Temperature
Summer
25°C or Higher
Spring/Fall
25°C ~ 10°C
Winter
0°C or Lower
WT5C/WTE5C/WT5CSG WATER TRAILER • OPERATION MANUAL — REV. #4 (03/14/17) — PAGE 17
UPPER LIMIT
Oil Type
SAE 10W-30
SAE 10W-30/20
SAE 10W-10
FUEL CHECK
DANGER
Motor fuels are highly flammable and can be
dangerous if mishandled. DO NOT smoke
while refueling. DO NOT attempt to refuel if
the engine is hot or running.
1. Remove the gasoline cap located on top of fuel tank.
2. Visually inspect to see if fuel level is low. If fuel is low,
replenish with unleaded fuel.
3. When refueling, be sure to use a strainer for filtration.
DO NOT top-off fuel. Wipe up any spilled fuel.

INSPECTION

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WT5C and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Wte5cWt5csg

Table of Contents