Settagmemory - Siemens SIMATIC RF310M Function Manual

RFID Reader Interface Reference
3.4 IRfReaderApi
3.4.16

SetTagMemory

SetTagMemory(tagID : string, memoryBank : uint,
Parameters
● tagID
● memoryBank
● startAddress
Base addresses are specified in bytes.
● dataLength
The length in bytes of the data to be written.
● Password
An access password if needed. The ISO18000-6B e.g. protocol does not support a
password. So just supply an empty string.
A password is a hexadecimal encoded string of up to eight characters.
● Buffer
The data to be written as a stream of bytes.
Return value(s)
None.
Exceptions
RfReaderApiException
56
startAddress : uint, dataLength : uint,
password :string, buffer : byte[]) : void
The ID of a tag whose data are to be modified, given as a hexadecimal encoded string.
The memory bank (0 - 3) to which data are to be written.
Valid Values for the air protocol 'ISO18000-6B,'
0 – USER MEM
Valid values for the air protocol 'EPCC1G2' are:
0 – Reserved
1 – EPC,
2 – TID and
3 – USER MEM.
Valid values for the air protocol 'RF300'"are:
0 – Memory
Valid values for the air protocol 'ISO15693' are:
0 – Memory
The base address within the memory bank to which data are to be written.
Error while communicating with the reader service. Check the Error
member for more information.
Function Manual, 12/2010, J31069-D0198-U001-A2-7618
Mobile Readers