Removal Of Air Filters - Daikin FTKS20KVLT Service Manual

Removal of Air Filters

1. Removal of Air Filters
Procedure
Step
1. Appearance features
2. Remove the air filters.
Open the front panel to
1
the position where it
stops.
Slightly push up the
2
center knob of the air
filter and release the
hooks.
3 Pull out the air filter
downward and remove
it.
2
Warning Be sure to wait for 10 minutes or more after turning off all power
supplies before disassembling work.
Procedure
Signal receiver
[ON/OFF] button Room temperature thermistor
Front panel
Dangerous: High voltage
A high voltage is applied to all
the electric circuits of this
product including
thermistors.
(R7900)
Operation lamp
TIMER lamp
INTELLIGENT
EYE lamp
INTELLIGENT
EYE sensor
(R7901)
(R7902)
Air filter
(R7903)
Si041049
Points
Warning
When the signal receiver
catches a signal from the
remote controller, the
receiving tone sounds and
the operation lamp blinks
immediately to confirm the
signal reception.
When the [ON/OFF] button
is kept pressed for 5
seconds, the forced cooling
operation is performed for
about 15 minutes.
The air filter is not marked
for difference between the
right and left sides.
The air filter can be set
easily by inserting it along
the guides.
Insert the air filter with the
"FRONT" mark faced up.
Be sure to insert the hooks
(at 2 lower positions) when
reassembling the air filter.
Removal Procedure