Standard Carriage Operation; Fork Positioning Carriage Operation - Xtreme XR1255 Operation And Safety Manual

Perkins 1204 tier 4 interim
Hide thumbs Also See for XR1255:
Table of Contents

Advertisement

Figure 69. Fork Ratings
(A) Maximum Load Capacity Rating (B) 24 inch Load Center
Because forks are always used in multiples, the total rating
of any combination of forks will be the sum of their rated
capacity. Other than block forks, all forks should be used in
matched pairs. Block forks should be used in matched sets.
The maximum load capacity for this forklift is 12,000 lbs. The
matched pair or set of forks used on this forklift should have
total load ratings which equal or exceed 12,000 lbs. When the
load rating of the forklift differs from the load capacity of the
forks, the lower value becomes the overall load capacity.

Standard Carriage Operation

The standard carriage uses manually adjustable forks and can
be tilted up or down by using the thumb stick on the control
handle.
A
B
Figure 70. Attachment Tilt Control Switch.
(A) Attachment Tilt Down (B) Attachment Tilt Up
Operation Manual

Fork Positioning Carriage Operation

Do not adjust forks when Fork Positioning Carriage is load-
ed. Adjusting forks when carriage is loaded may result
in loss of load or carriage damage. Always use the Fork
Positioning control handle to adjust the forks BEFORE
loading the carriage.
To move the forks outward, press the top button on the front
control handle, or move the auxiliary handle to the left. To
move the forks inward, press the lower button on the front
control handle, or move the auxiliary handle to the right.
Figure 71. Fork Positioning Control Handle
is rated to be equal or greater than 3,900 psi, which is the
maximum pressure of the forklift auxiliary hydraulic system
at the quick-disconnect couplers, could result in death or
serious injury.
When the auxiliary attachment control lever is moved right
or left it activates hydraulic pressure through the quick attach
couplers to move the carriage.
60
Operation
Caution
Warning
Hydraulic attachments have a
maximum hydraulic pressure
rating. Failure to make sure the
attachment is equipped with
a pressure reducing valve, or

Advertisement

Table of Contents
loading

Table of Contents