Table of Contents
Advertisement
Operation
NOTE: The boom angle indicator is a plumb arrow with
angular graduations from -5 to +700.
Figure 88. Boom Angle Indicator
Reading Load Capacity Charts
To accurately read the load capacity charts, you must
determine three (3) things:
•
Weight of the load being lifted
•
Height of structure where load is to be placed
•
Distance from front tires where load will be placed
XR1255 LOAD CHART OUTRIGGERS DOWN - STANDARD CARRIAGE
18
17
NO OPERATION
16
ABOVE 55 DEGREES
15
BOOM ANGLE WITH
REAR AXLE UNLOCKED.
14
13
LOAD RATINGS
SHOWN ARE FOR
12
VEHICLES EQUIPPED
11
WITH FOAM FILLED
TYRES ONLY.
10
9
2,720 KG AT
600MM MIN
8
CAPACITY FORK
7
(5,440 KG PAIR).
6
FORK DIMENSIONS (MM)
5
102 X 57 X 1524
4
CARRIAGE P/N
3
25419-010
LOAD CENTRE
2
LOAD CENTRE
1
0
11.5
LOAD CHART
13
P/N 17251-100
00
REV
LIFTING (STATIONARY) - RATED LOAD ON FORKS
SPECIFICATIONS FOR SAFE USE
TYRE SIZE: 15.5 X 25
(G2 or E3 FOAM FILLED)
MAX WHEEL LOADING: 9400 KG
MINIMUM TYRE MASS: 435 KG
IN SERVICE WIND SPEED: 10 M/S - 36KM/H
FORK LOAD CENTRE: 600 MM
GROUND CONDITIONS: SOLID SURFACES
FOR BOTH LIFTING AND TRAVELLING, SLOPE
RATINGS LISTED FOR BOTH CONDITIONS
PICK & CARRY INFORMATION: MACHINE POSITION - BOOM FULLY RETRACTED WITH RATED LOAD NO MORE THAN 300MM ABOVE GROUND
STANDARD USED: (AS 1418.19)
60
55
50
45
40
35
30
25
20
15
10
5
0
5
12
11
10
9
8
7
6
5
THE
CHASSIS
MUST
REMAIN
LEVEL
4º
4º
MAX
MAX
TRAVEL SPEED WITH RATED LOAD - 0.4M/S WALKING SPEED
For example:
1. The operator determines load weight and makes sure load
does not exceed fork, attachment, or boom capacity.
The load is 6,614 lbs.
2. The operator safely moves the load to a loading position.
•
places forks under load
•
tilts and raises load safely
•
fully retracts boom
•
drives forklift to position perpendicular to structure
•
levels the forklift
3. The operator determines height of structure where load is
to be placed.
The structure height is 26.2 feet from ground level.
4. The operator determines distance from front tires where
load will be placed.
The distance in front of forklift where load will be placed is
19.6 feet.
5. Operator reads load capacity chart for attachment carriage
to learn it will be safe to place the load at any boom angle with
the boom extend letter "E" showing.
LOAD CENTRE
71
17.2
65
600MM
LOAD
CENTRE
8.9
600MM
LOAD
CENTRE
LOAD CENTRE
LOAD CENTRE
REACH METER
4
3
2
1
0
-1
-2
TRAVELLING (PICK & CARRY) - RATED LOAD ON FORKS
10º
10º
MAX
MAX
69
5º
MAX
Figure 89. Load Capacity Chart
Operation Manual
Advertisement
Table of Contents
