Connecting And Disconnecting The Modem In Stand Alone Mode - Fortinet FortiGate FortiGate-100A Install Manual

Configuring the modem interface
1
2
3
4
5
6

Connecting and disconnecting the modem in Stand alone mode

1
2
3
4
5
1
2
FortiGate-60 series and FortiGate-100A FortiOS 3.0 MR4 Install Guide
01-30004-0266-20070831
You can configure and use the modem in NAT/Route mode only.
To configure modem settings
Go to System > Network > Modem.
Select Enable Modem.
Change any of the dial-up connection settings.
Enter the settings for Dial-up Account 1 settings.
If you have multiple dial-up accounts, enter Phone Number, User Name, and
Password for Dial-up Account 2 and Dial-up Account 3.
Select Apply.
To connect to a dial-up account
Go to System > Network > Modem.
Select Enable Modem.
Make sure there is correct information in one or more Dial-up Accounts.
Select Apply if you make any configuration changes.
Select Dial Now.
The FortiGate unit initiates dialing into each dial-up account in turn until the
modem connects to an ISP.
not active The modem interface is not connected to the ISP.
active The modem interface is attempting to connect to the ISP, or is connected
to the ISP.
A green check mark indicates the active dial-up account.
The IP address and netmask are assigned to the modem interface. Go to
System > Network > Interface to verify the IP address and netmask.
To disconnect the modem
Use the following procedure to disconnect the modem from a dial-up account.
Go to System > Network > Modem.
Select Hang Up if you want to disconnect from the dial-up account.
Connecting and disconnecting the modem in Stand alone mode
53