Fortinet FortiGate FortiGate-100A Install Manual page 42

Transparent mode installation
42
To change to Transparent mode using the CLI
1 Make sure you are logged into the CLI.
2 Switch to Transparent mode. Enter:
config system settings
set opmode transparent
set manageip <address_ip> <netmask>
set gateway <address_gateway>
end
After a few seconds, the following prompt appears:
Changing to TP mode
3 When the login prompt appears, enter the following:
get system settings
The CLI displays the status of the FortiGate unit including the management IP
address and netmask:
opmode
manageip
You should verify the DNS server settings are correct. The DNS settings carry
over from NAT/Route mode and may not be correct for your specific Transparent
mode configuration. Use
settings.
To verify the DNS server settings
Enter the following commands to verify the FortiGate unit's DNS server settings:
show system dns
The above CLI command should give you the following DNS server setting
information:
config system dns
set primary 293.44.75.21
set secondary 293.44.75.22
set fwdintf internal
end
To configure DNS server settings
Set the primary and secondary DNS server IP addresses. Enter:
config system dns
set primary <address_ip>
set secondary <address_ip>
end
Example
config system dns
set primary 293.44.75.21
set secondary 293.44.75.22
end
FortiGate-60 series and FortiGate-100A FortiOS 3.0 MR4 Install Guide
: transparent
: <address_ip><netmask>
Table 10 on page 41 to configure the DNS server
Configuring the FortiGate unit
01-30004-0266-20070831